Installation Guide
Follow these steps for a safe and efficient installation of your JH Heatsup.
Safety First
Installation must be performed by a qualified electrician in accordance with local electrical codes. Always ensure the power supply is switched off at the main panel before starting installation.
Tools Required
Installation Steps
Positioning & Measuring
Choose a location on the ceiling or high wall. For optimal performance, the heater should be installed 2.2m to 2.5m above the floor. Mark the drilling points according to the mounting bracket dimensions provided in the box.
- Maintain minimum 0.5m distance from side walls.
- Ensure minimum 0.2m distance from the ceiling (if wall mounted).
Mounting the Brackets
Drill holes at the marked positions and insert the expansion bolts. Securely fasten the mounting brackets to the surface. Slide the heater's rear sliding brackets into the mounted brackets and tighten the adjusting screws to set the desired angle (0°, 15°, 30°, or 45°).
Electrical Connection
Connect the power cable to the mains supply. Ensure proper grounding. For units with remote control, ensure the receiver eye is visible for the remote to work effectively.
Testing
Switch on the power. The heater should reach full operating temperature within 5 minutes. You may notice a slight smell during the first use; this is normal and will dissipate quickly.
View Product Manual
Access the complete installation manual with diagrams for your specific model.